Bluetooth: hci_qca: Fix qca6390 enable failure after warm reboot

Warm reboot can not reset controller qca6390 due to
lack of controllable power supply, so causes firmware
download failure during enable.

Fixed by sending VSC EDL_SOC_RESET to reset qca6390
within added device shutdown implementation.

Signed-off-by: Zijun Hu <[email protected]>
Tested-by: Zijun Hu <[email protected]>
Signed-off-by: Marcel Holtmann <[email protected]>

Author: Zijun Hu

drivers/bluetooth/hci_qca.c

@@ -1975,6 +1975,38 @@ static void qca_serdev_remove(struct serdev_device *serdev)
 	hci_uart_unregister_device(&qcadev->serdev_hu);
 }
 
+static void qca_serdev_shutdown(struct device *dev)
+{
+	int ret;
+	int timeout = msecs_to_jiffies(CMD_TRANS_TIMEOUT_MS);
+	struct serdev_device *serdev = to_serdev_device(dev);
+	struct qca_serdev *qcadev = serdev_device_get_drvdata(serdev);
+	const u8 ibs_wake_cmd[] = { 0xFD };
+	const u8 edl_reset_soc_cmd[] = { 0x01, 0x00, 0xFC, 0x01, 0x05 };
+
+	if (qcadev->btsoc_type == QCA_QCA6390) {
+		serdev_device_write_flush(serdev);
+		ret = serdev_device_write_buf(serdev, ibs_wake_cmd,
+					      sizeof(ibs_wake_cmd));
+		if (ret < 0) {
+			BT_ERR("QCA send IBS_WAKE_IND error: %d", ret);
+			return;
+		}
+		serdev_device_wait_until_sent(serdev, timeout);
+		usleep_range(8000, 10000);
+
+		serdev_device_write_flush(serdev);
+		ret = serdev_device_write_buf(serdev, edl_reset_soc_cmd,
+					      sizeof(edl_reset_soc_cmd));
+		if (ret < 0) {
+			BT_ERR("QCA send EDL_RESET_REQ error: %d", ret);
+			return;
+		}
+		serdev_device_wait_until_sent(serdev, timeout);
+		usleep_range(8000, 10000);
+	}
+}
+
 static int __maybe_unused qca_suspend(struct device *dev)
 {
 	struct serdev_device *serdev = to_serdev_device(dev);
@@ -2102,6 +2134,7 @@ static struct serdev_device_driver qca_serdev_driver = {
 		.name = "hci_uart_qca",
 		.of_match_table = of_match_ptr(qca_bluetooth_of_match),
 		.acpi_match_table = ACPI_PTR(qca_bluetooth_acpi_match),
+		.shutdown = qca_serdev_shutdown,
 		.pm = &qca_pm_ops,
 	},
 };