-
|
Hello everyone. I want to try Devicescript and I've bought Lilygo t-display-s3 board for it https://www.lilygo.cc/products/t-display-s3 This board has a 1.9-inch display with st7789 driver, which is connected by 8080 interface. As I understand, ST7789 Devicescript driver uses only SPI interface. My question is how to work with display in this case? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 5 replies
-
|
Unfortunately the parallel interface is currently unsupported. Maybe it's possible to switch display into spi mode with some pin settings? |
Beta Was this translation helpful? Give feedback.
-
|
Unfortunately not :( IM pins directly connected to GND. It means the 8080 interface only supported for this board. My fault. I had to read DS docs carefully before purchasing |
Beta Was this translation helpful? Give feedback.
-
|
Ouch, we'll gladly add a caution note about this detail. Do you recall which documentation page you looked at? |
Beta Was this translation helpful? Give feedback.
-
|
I've added a note in docs 39215eb |
Beta Was this translation helpful? Give feedback.
-
|
It would be great if you also add a caution here https://microsoft.github.io/devicescript/developer/graphics |
Beta Was this translation helpful? Give feedback.
-
|
added! |
Beta Was this translation helpful? Give feedback.
Unfortunately the parallel interface is currently unsupported. Maybe it's possible to switch display into spi mode with some pin settings?